Members | Sign In
ScannerDanner Forum > Post your repair questions here
avatar

2003 outlander crank won't start

posted Jun 06, 2016 18:51:25 by AndresRohena
Hello guys i just want to make sure i am in the right track got this 2003 mitsubishi outlander 2.4l and i think is a pull up design crank sensor i have my 12volts my good ground i dont have a lab scope to see a square wave but since i think is a pull up desing can i use a led tester light to see or hear my inyector cliking or see at my scanner theres a way my signal going on and off ? The crank sensor is inside the timing belt
[Last edited Jun 15, 2016 04:34:55]
page   1
2 replies
avatar
AndresRohena said Jun 06, 2016 18:53:07
As you know want to make sure is the crank sensor or the reluctor wheel because this crank sensor is a pain to get to them is like doing the timing belt and i just want to make sure before beginning taking all apart
avatar
Tyler said Jun 09, 2016 03:12:25
Hey sir! Could I get you to repost this in the Repair section? We can totally help you further there.
Login below to reply: